Incubator Bayi + Lampu Phototeraphy Mobile

No Comments on Incubator Bayi + Lampu Phototeraphy Mobile

Incubator bayi + lampu phototeraphy mobile

Incubator bayi + lampu phototeraphy mobile


Onemed


  • Other specification
    • Infant mattress width 31cm
    • Infant mattress length 63cm
    • Noise level within hood environment <60dB (A) (Base on surroundung environment noise below 45dB)
    • Carbon diaxide(Co2) level within the hood less than 0.5% when a mixture of Co2 in air is delivered at 750ml/min at a point 10cm above the center of the mattress.
    • Air velocity over mattress  less than 0.35m/s

  • Temperature control range and correlative
    • Air mode control 25-37°
    • Temperature rise time (typical @22°C ambient) < 45minutes
    • Temperature variability < 0.5°C
    • Temperature uniformity (level mattress) <0.8°C
    • Alarm
      • Power alarm power failure
      • Motor alarm  motor failure
      • Motor run speed too low
      • Air flow stop
      • Sensor alarm  Air temperature sensor failure
      • Isolate overheating sensor failure
      • Air flow sensor failed
      • Temperature deviation alarm High/low air temperature
      • Over temperature alarm Air temperature control mode
      • Activated if incubator temperature not exceeds 38°C
      • E² ROM failed  internal malfunction
  • Environment temperature (not to use in the environment exceed specified)
    • Operating range  +20-+30°C
    • Storage range -40-+70°CEnvironment humidity
    • Operating range 30%RH-75%RH non-condensing
    • Storage range  < 80% RH non-condensing
  • Air Velocity Ambient Air Velocity  < 0.3 m/s
    Atmospheric Pressure
  • Shipment & store atmospheric pressure range 500hPa-1060hPa
    Operating atmospheric pressure range 700hPa-1060hPa
  • Power requirements
    • AC220V-230/AC110V-120V, 50/60Hz
  • Power requirements
    • 680VA maximum
  • Power outlet
    • AC220V-230V, 50/60Hz,Current 2A max AC110V-AC120V,50/60Hz,Current 2Amax
  • Physical Dimensions
    • Height from mattress to floor 90cm
    • Width 100cm
    • Depth 150cm
    • Incubator main body weight > 60kg
    • Stand weight > 10kg
    • I.V Pole max. Load 20N
    • Hood max. Load 4kg
    • Infant mattress max. Load 10kg

Switch to our mobile site